![]() Tire circumference can be determined by either of the following two methods: For instructions on how to start measurement, refer to "Starting measurement". Setup is completed and the computer switches to the measurement screen. * All data is deleted and the computer is reset to its factory default settings.Įnter the tire circumference of the front wheel in mm.Įach time MODE is pressed and held, settings switch from time display mode, to hours, to minutes. Press the AC button on the back of the computer. When using the computer for the first time, configure the initial settings. If the speed is not displayed, refer to the attachment conditions in steps 1, 2, and 4 again. Attach/detach computerĪfter attaching the computer, rotate the front wheel gently to check that current speed is displayed on the computer. * The magnet may be mounted at any position on spoke as long as attachment conditions are satisfied. The clearance between the speed sensor and the magnet is within 5 mm (3/16"). The magnet passes through the speed sensor zone. Mount the speed sensor in a position where the distance from the computer to the speed sensor is within the signal range. ![]() When mounting the bracket on a handlebar, adjust the angle of the bracket so that the back of the computer faces the speed sensor when the computer is attached.Ĭut the bracket band so that cut end will not cause injury. ![]() Cateye Padrone CC-PA100W - Cyclocomputer Manual
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |